Coaxial stripping machine is a kind of harness processing equipment with very high work efficiency. Compared with the traditional stripping machine, the coaxial stripping machine has a higher degree of intelligence, and can save labor costs and can also meet the requirements of each Wire harness production and processing needs. Now coaxial peeling machine has been widely used in the field of life, to understand the operation method of coaxial peeling machine, but also can better guide the practice of production, let Zhou Hao Electronics to give us a simple coaxial peeling machine operation process!

First of all, it is necessary to check the line before starting the coaxial debarking machine to ensure that there is no problem with the line connection. Then set up relevant data according to requirements to ensure the accuracy of stripping, so as to meet the basic needs; Secondly, in the operation, attention should be paid to all aspects of detail, keep the incoming line position from being blocked, noise should be checked in time, and reasonable Guided wire feeding.

Finally, the coaxial stripping machine must be adjusted according to the actual situation. In terms of preparation, the length of the cutting line, the number of rollings, and the number of strips should be separately set according to the requirements. The cross section of the cut wire should meet the requirements. During the commissioning process, the performance of the take-up motor, the transmission line motor, and the main motor must be carefully checked to ensure safe operation without slippage. Safe operation of the coaxial debarker requires attention to all aspects of detail, in strict accordance with the relevant instructions and procedures to operate, grasp the working principle of the coaxial debarking machine, so as to better guide the operation.

While operating the coaxial debarking machine, it is also necessary to understand the relevant precautions. The operator of the coaxial debarker must be trained by a professional to perform the operation. The operator should be familiar with the general performance and structure of the machine. , Master equipment failure prevention, judgment and emergency measures. The machine should be suspended when leaving the machine in the production process, so that people can stop the machine. Do not place your fingers near the knife holder and collet during operation to prevent pinching. In the event of a fault, the machine should be shut down immediately, the circuit should be short-circuited, smoke should be emitted, and the power supply should be cut off in the event of a leakage. After the fault is removed, the device can be switched on. The device must not be overloaded with faults.

The above is about the operating procedures and related precautions of the coaxial peeling machine. If you want to know more about the coaxial peeling machine, you can go to the official website of Dongguan Zhouhao Electronics Co., Ltd. to learn more.