The degree of automation of the coaxial peeling machine in the industry is still very high, so as long as professional technical personnel can carry out simple explanation training to get started, and the operation of the coaxial peeling machine is also very simple, the maintenance cost of the machine is also low, Therefore it is a very good harness processing equipment.

First, the preparation of the coaxial peeler operation

1. Check whether the parts of the machine are loose and check whether the accessories are installed correctly.

2. Test the machine and check if the machine is running normally and if there is any abnormal sound

3. turn on the power, check the power indicator is normal, check the machine is back to leakage

4、Check if the processed wire is within the processing range of this machine

Second, coaxial peeling machine operation details

1、According to the requirements of the process file, the cable stripping length, stripping length of the core wire, adjusting the position of the upper and lower (left and right) cutters, checking whether the compressed air supply is normal, adjusting the air flow of the air cylinder, plugging in the power supply, and starting the device with the foot switch run.

2、After cutting a few roots, check the length of each product and the quality of the core wire to ensure that it conforms to the process documentation. After the product is inspected, it can be turned on continuously for continuous production.

3、During the stripping process, the hand cannot enter the interior of the protective cover to prevent the machine from hurting people.

4、Stop the machine halfway, please unplug the power plug, so that people leave, the machine power outage, to prevent others from accidentally stepping on the foot switch caused pinching.

5、If you need to replace the stripping blade, you must first stop and stop the gas before you can replace it.

Third,Coaxial stripping machine needs precautions during use

1、The operator of the coaxial stripping machine must be trained by personnel trained by a professional to operate. The operator should be familiar with the general performance and structure of the machine, master equipment failure prevention, judgment and emergency treatment measures.

2、The machine should be suspended when leaving the machine in the production process, so that people can stop the machine.

3、Do not place your fingers near the knife holder and collet during operation to prevent pinching.

4、In the event of a fault, the machine should be shut down immediately, the circuit should be short-circuited, smoke should be emitted, and the power supply should be cut off in the event of a leakage. After the fault is removed, the device can be switched on. The device must not be overloaded with faults.