The semi-automatic coaxial debarker is a type of processing equipment that is widely seen in the wire harness processing market. The processing range is very wide. Therefore, it receives the hot pursuit of the public, and the semi-automatic coaxial debarker has a more flexible operation than the automatic coaxial debarker. Environment, light and easy to move, the price is much cheaper. The precision of processing coaxial cable is also very high, which is very suitable for all types of small and medium-sized wire harness processing enterprises to purchase in batches. It is also very important to purchase a machine to understand the relevant operating knowledge. Let Zhouhao Electronics give us a detailed explanation of semi-automatic coaxial How to operate the peeling machine!

One: Before the job

1.Before the operation, the employee strictly inspects the equipment according to the spot inspection system and makes records;

2.Before starting the machine, it is necessary to check whether the accessories of the machine are installed correctly. After confirming that there are no problems, you can turn on the machine.

3.Make sure that the processing machine is in good condition, reliable in installation, and well lubricated.

Two: In operation

1.According to the process document requirements cable stripping length, core stripping length, adjust the up and down (left and right) cutter position, check the machine is normal, and adjust the harness related processing parameters, plug in the power, use the foot switch to control the device to start running;

2.After cutting a few roots, check the length of each product and the quality of the core wire to ensure that it conforms to the process documentation. After inspection of the product, check the normal start-up and continuous production.

3.During stripping, the hand cannot enter the interior of the shield to prevent the machine from hurting people;

4.Stop the machine halfway, please unplug the power plug, so that people leave, the machine power failure, to prevent others from mistakenly stepping on the foot switch caused pinching;

5.If you need to replace the stripping blade, you must first stop working before you can replace it.

6.If abnormal conditions are found during use, power should be cut off immediately and professional maintenance personnel should be notified to perform maintenance.

7.During the operation, the operators are concentrated and are strictly prohibited from doing anything unrelated to production.

Three: The job is over

1.After the production plan is completed, the power of the equipment should be turned off;

2.Turn off the equipment's main power supply, clean the machine and surrounding sanitation before leaving work.

Four: safety precautions

1.In the event of smoke or smell in the equipment circuit, abnormal sound, or abnormal conditions or if equipment is found to be damaged or the components fall off, unplug the power plug immediately and look for maintenance personnel.

2.When the device is turned on, do not place your finger inside the stripping knife or inside the device to prevent injury to your fingers.

3.It is forbidden to use tools to play at the production site. It is forbidden to stack tools, materials, and other items on the equipment.

4.Maintenance should pay attention to safety protection, maintenance work must be off.